Dieless oscillating knife pattern cutting table comparation to hand cutting and die cutting
Dieless[Dieless?:Die-less short run fast sample maker] oscillating knife pattern
cutting table[cutting table?:sample maker cutting table] comparation to hand cutting and
die cutting[die cutting?:die cutting]
Any of the following conditions make
dieless oscillating knife pattern
cutting table the logical solution compared to traditional
die cutting or cutting by hand:
Eliminate cutting dies and related problems & costs, the will need one die cut mould to make each pattern, and the mould always very expensive.
Increase production flexibility, easy to change design, just change in computer and make a new pattern in few minutes.
Reduce time to market-design a component and produce it in seconds
Rapid prototyping, samples & pre-production runs, make the sample in few minutes, and make samll production withour making dies.
Material savings and reduced scrap rate, layout in computer, cut according the design, save much material than hand cutting and
die cutting.
CAD/CAM System used to design patterns, easy to design or change design.
