cutter glossary of CUTCNC[CUTCNC?:cutting machine sample maker manufacturer] pattern making[pattern making?:pattern making] cutting table[cutting table?:sample maker cutting table]
（1）head ：can drive pen pole/pen/knife /creasing tool to move from right to left side.
（2）the pole holder of pen ：control pen pole/pen/creasing tool, drive them to UP/DOWN move.
（3）Y axis ：To control head, can move from right side to left side..
（4）operating platform ：cutting/drawing/creasing in here.
（5）control panel ：can set and use all kind of cutter function
（6）parallel interface ：use compatible Centronic parallel interface to connect cutter to computer.
（7）serial interface ：use RS232C serial interface to connect cutter to computer.
（8）AC supply socket：one port connect to supply cable, another port connect to socket.
（9）insurance pipe seat：5A insurance pipe.
（10）control panel interface ：use a data cable to connect to control panel.
（11）Z-axis limit signal socket：connect limit sensor of head.
（12）Y-axis limit signal socket：connect Y-axis limit sensor.
（13）X-axis limit signal socket：connect X-axis limit sensor.
（14）Z-axis motor socket：connect to head motor.
（15）Y-axis motor socket：connect to Y-axis motor of beam.
（16）X-axis motor socket：connect to X-axis motor.
（17）vacuum pump socket：connect to the contactor of vacuum pump.
